Before drywall was invented, one of the most common building materials for finishing ceilings was ornamental rolled tin. Tin ceilings have been experiencing a revival as manufacturers are producing both stamped tin tiles and Styrofoam tiles that emulate actual tin ceiling tiles. Not everyone is fond of tin ceilings, however, and some may wish to remove them. Taking down an old tin ceiling isn't difficult, but it is messy. Preparing the work site in advance will help you to successfully start and finish the job in a timely fashion.
Instructions
1. Clear everything from the room and, if the floor is carpeted or has hardwood floors, lay down tarps to protect it. Rolled tin ceiling is unwieldy and has sharp edges. It can cut and gouge surfaces.
2. Turn off the electricity, and remove any ceiling light fixtures.
3. Set up a ladder next to the wall in the corner of the room. Climb the ladder with a crowbar, and work it under the tin cornice--the ornamental, dimensional tin that camouflages the seam between the tin ceiling and the wall. Start popping the cornice away from the wall and ceiling. Systematically work the perimeter of the room until you have taken down all of the tin cornice.
4. Examine the seams of the rolled tin ceiling where one roll butts up against the next. Rolled tin ceiling was usually attached to 1x2-inch strips of wood pounded to the ceiling. Set up the ladder at one end of the room, and work the crowbar behind the end of one strip of tin to pop it away from the 1x2-inch strips on either side of the roll.
5. Continue to pop the tin loose. When enough is hanging far enough down from the ceiling, climb down from the ladder and try to pull down the rest of the roll by hand. If the nails won't give way, move the ladder, climb back up and continue popping the tin free with the crowbar.
6. Roll up each length of tin, and bind it with strapping tape. Carry the rolls of tin outside, and haul them away.,
Tags: 1x2-inch strips, away from, , with crowbar