Installing decorative ceiling tiles can add a touch of elegance to an otherwise plain or boring ceiling. Decorative ceiling tiles are relatively light, especially faux tiles, and easy to install. The only drawback is that the installation process can be time-consuming and somewhat tedious. But the lasting effect of the decorative ceiling tiles is the charm and ambiance of the room.
Instructions
1. Remove fixtures such as lamps and vent frames from the ceiling. Use a screwdriver to remove all the screws holding the fixtures in place.
2. Using a tape measure, measure the length and width of the ceiling. Divide each measurement in half and mark that measurement for all sides using a pencil. Then use a chalk line to mark the halves on the ceiling. The result should be four rectangles.
3. Apply small dabs of tile adhesive throughout the back of the tile, including the edges, using a small taping knife.
4. Set the first four tiles into each corner where the lines meet in the middle of the ceiling. Press gently with hands.
5. Measure the edge tiles by measuring the remaining length on both sides of the tiles. For example, align the measurement from the last tile before the edges of the ceiling; measure the length on either side, because the measurements may differ in quarter inches or less. Then measure and mark the two measurements on a new tile and cut with a utility knife. Make sure that the piece fits before applying adhesive.
6. Put the tile in place with adhesive. Then cut out the hole for fixtures with a utility knife.
Tags: ceiling tiles, with utility knife, measure length, utility knife, with utility