Friday, February 18, 2011

Install A Halogen Replacement Bulb

Halogen light bulbs (or "lamps," as they are called), give off a brighter light than the older incandescent bulbs. However, halogen lamps also create far more heat, so you must be careful where you place these lamps, and keep flammable materials away from them. Most halogen lamps last a long time, but all of them will burn out eventually and will need to be replaced. Since halogens do not simply screw in like the older incandescent bulbs, you must take care when replacing them. The procedure is not difficult, but it does take a little time.








Instructions


1. Unplug the halogen floor lamp; or, if you are replacing the bulb in a ceiling fixture, turn off the power at the fuse box. If the lamp has been burning recently, allow it to cool before attempting to replace it.


2. Remove the tempered glass cover over the halogen bulb. You may have to remove small clamps or screws that hold the glass cover in place. Set the glass cover and any screws or clamps aside.


3. Using a cotton handkerchief or paper towel, grasp the halogen bulb and remove it from the fixture. Some small bulbs have straight pins in their bases, in which case you can simply push in and then pull out the bulbs. Other bulbs twist and lock, rather like a fluorescent tube, while some halogen bulbs are held in place by a spring-loaded holder--so you will need to press the bulb against one end or the other.


4. Make sure the new bulb is of the same type, size, and wattage as the old one. Carefully take the new bulb out of the container; do not touch it with your bare fingers. Use a cotton handkerchief to remove it from the package and place it into the light fixture.


5. When the bulb is firmly in place, replace the tempered glass cover and any screws or clamps you removed earlier. Plug in the floor lamp or turn the power on at the fuse box, then turn on the light.

Tags: glass cover, cotton handkerchief, cover screws, cover screws clamps, floor lamp