Running an Ethernet cable through the wall allows networking with minimal visual mess.
Running an
Instructions
1. Map out the best path for the cable to run from your computer to its destination. Consider a path that crosses as few framing joists as possible, such as entering the wall and going up through the ceiling to a spot above the final destination then down through the wall.
2. Cut a 3-inch by 5-inch hole where you want the cable to enter the wall using the keyhole saw. Cut the same dimension holes over any joists the Ethernet cable will cross over and where the wall and ceiling intersect over your desired route.
3. Run the cable through the wall using the fishing tape and the holes you cut as a route.
4. Chisel a groove in any joists the cable crosses to allow the cable to lay flush as it passes over to the next wall space. Install a nail guard over each joist with a cable passing over it to ensure the cable isn't accidentally damaged down the road by a nail.
5. Patch the holes by returning the cut dry wall squares to the place from which they were taken. Using a drywall patching compound, patch around the squares.
6. Paint the wall where the drywall was cut.
Tags: through wall, Ethernet cable,