Caulking Crown Molding.
Learning caulk crown molding is a necessary skill for anyone who has this beautiful architectural feature in their home. Expansion gaps between the molding and the wall/ceiling are fairly common as a result of the natural heating and cooling process that takes place during each new season. Also, caulking the crown molding is a necessary step if it has just been installed and you intend to paint it.
Instructions
Caulk Crown Molding
1. Insert the trim caulk into your caulking gun. Any caulk that contains silicone and acrylic will work fine. Make sure it's made for use on trim and it's paintable. These caulks are flexible and have good adhesion.
2. Use a small pair of scissors or knife to cut the top off the caulk at a 45-degree angle. Try to make the opening about 1/4-inch diameter, as this allows you to have more control over the amount of caulk that comes out.
3. Position the ladder near the wall you will be working on. Carefully climb the ladder until you can comfortably and easily reach the crown molding with your hands and caulking gun.
4. Use the gun to squirt caulk into any gaps that seem apparent, keeping in mind gaps usually form above and below the molding, as well as in the joints in the inside corners of the room where two pieces of crown molding join. Only use enough caulk to fill in the gap.
5. Glide the rag over the caulk, applying gentle pressure. This ensures you are pushing the caulk as far into the gaps as you possibly can, and it allows you to spread it into a thin, even layer. If you don't mind getting a little caulk on your fingers, you can also run your finger across the gap to evenly distribute the caulk.
6. Allow the caulk to dry for 30 minutes before you begin painting the crown molding or the walls.
Tags: caulk into, , Caulk Crown, Caulk Crown Molding, caulk into gaps