Wednesday, October 10, 2012

Install Barrington Outdoor Lighting

Entry lights offer safety and a design element to a home.


Barrington outdoor lights are manufactured by ELK Lighting, Inc., and are catalogued as the Barrington Gate Collection. These lights are inspired by the English Manor designed homes found in the Southern United States. The lights are made of a hazelnut bronze finished cast aluminum and custom made water glass. Each piece is slightly different, putting the lights into the high-quality custom designed category. The collection consists of wall, sconce, post, hanging, and flush mount lights. This article describes install a Barrington Gate sconce light that is replacing an existing outdoor wall sconce.


Instructions


Instructions








1. Turn off electricity to the light. Unscrew the base plate of the old light using a screwdriver. Remove the wire nuts and disconnect the wires. Set the old light aside.








2. Strip an inch of insulation off of the new wires to prepare them to be attached to the house wires. Inspect the house wires for damage or wear. If you are unsure about the condition of the exposed wires, cut them back and strip off a new section as was done with the wires on the light.


3. Twist the wires together, matching colors. Twist the wire nuts onto the connected wires. Push the wires into the junction box.


4. Mount the light onto the wall. Screw in tightly, but do not over tighten it. Over tightening can lead to damage of the base plate or the wall. Turn the circuit breaker back on and test the light. If it is working, caulk around the outside of the base plate to seal it from moisture.

Tags: base plate, Barrington Gate, house wires, wall sconce, wire nuts