Clean Paint From A Ceiling After A Painting Mistake

Sometimes a painting error will appear while the ceiling paint is still wet. If this happens, then perhaps you deal with the problem immediately. However, the most likely scenario is that the problem will not be visible until the paint is dry, in which case, you will have ample time to contemplate the situation.

Instructions

When The Paint is Wet

1. Stop painting when you see the mistake and take a step back to access the situation.

2. Correct the mistake while the paint is still wet. Sometimes this can be done if you have simply applied paint with your roller in a way that leaves blotches, streaks or areas of built-up paint, for these kinds of problem areas can be usually corrected by spreading out the wet paint in a way that leaves an even surface. However, if there is a foreign material in the paint or you have some problems with stains bleeding through, then it is best to remove the paint right away before it dries.

3. Remove the paint with a clean rag while the paint is still wet. Do this as soon as you detect the mistake, so that you can complete the task before the paint dries. Make sure any foreign material that inadvertently got mixed in with the paint is removed and also be certain that there are no drips or areas of built-up paint remaining on the ceiling.

4. Let the paint dry and then proceed with the painting, if possible.

AfterThe Paint is Dry.

5. Sand all places, where the paint is built up with a hand-held sheet of medium grade sandpaper. If there is a lot of sanding that needs to be done, you can use an orbital or vibrating sander. The sander should be used to remove high spots and places, where a foreign material has contaminated the paint.

6. Wipe the ceiling clean of all dust with a damp rag or one that contains a little bit of paint thinner.

7. Try cleaning areas of thick paint with a rag moistened with a moderate amount of paint thinner or turpentine. Start out using as little solvent as possible and increase the amount used only if the dry paint is difficult to remove. If this method does not work, your best recourse may be to cover ceiling with a heavy duty sealer-primer (alcohol or lacquer based).

8. Clean all areas where a solvent was applied with clear water and then a soapy solution.

9. Rinse again with clear cold water.

Tags: foreign material, paint still, paint with, areas built-up, areas built-up paint