Thursday, May 19, 2011

Scrape & Sand Interior Molding

Flat edged paint scraper


When planning a new decorating scheme, a homeowner should take into account the paint on his trim and molding. It may need to be sanded or scraped to match the new look of the room. Because chemical paint and varnish removal products should not be used indoors, the work must be done by hand. This is a time-consuming process; however, a well-prepared surface will make painting or staining it the next time easy.


Instructions


1. Cover the floor and any furniture nearby with a plastic drop cloth. Tuck the drop cloth in tightly around the furniture so that dust does not blow in underneath the covering. Remove any electronic equipment such as computers and televisions from the immediate area.


2. Scrape loosened paint with a paint scraper. Hold the scraper firmly in both hands. Place the edge of the blade against the peeling paint and slide it slowly away from your body to avoid gouging the wood. Work in an up and down motion first, starting at the top of the molding.


3. Scrape any leftover chunks that are peeling by scraping them from side to side with the paint scraper. Start at the top of the trim piece. Place the corner of the blade at the edge of the peeling paint and glide it over the area very slowly.


4. Put on a dust mask for protection. Sand the molding with a detail sander, using medium-grit sandpaper. Move the sander slowly in a back and forth motion beginning with the woodwork at the top. Dust the molding with a feather duster so you can see if all the paint is being removed before continuing to another area.


5. Sand over any areas that have paint remaining on them by going from side to side with the detail sander. Stop often to wipe away the dust with a feather duster. Check the sanding belt to make sure it is not clogged with debris or worn through. Clean or replace the sanding belt as needed.


6. Scrape along any outside edges that could not be reached with the detail sander by using a paint scraper. Work with only the edge of the blade in order to reach into tight areas. Remove any stubborn sections of paint with a small wire brush or steel wool pad using light pressure.


7. Lightly sand over any detail molding by hand using fine grit sandpaper. Work in a circular motion over the detailing. Brush away dust with a feather duster. Use a piece of steel wool dipped in warm water to remove paint from the grooves of the detail molding. Use light pressure to avoid scratching the piece.








8. Wipe down the sanded molding with a solution of mild detergent and warm water. Use a soft cloth dipped in the cleaning solution to clean the molding. Let the area dry, then check for any last remaining paint. Sand these areas individually if needed.


9. Remove the drop cloth from your furniture. Take outside and shake off the dust before folding and storing it. Dispose of the cleaning solution by dumping it down a kitchen drain. Gather your sander, scraper and wire brush and place in storage area. Discard your dust mask and steel wool pads in a trash container.

Tags: paint scraper, detail sander, drop cloth, feather duster, molding with, steel wool, with detail