Replace the Heating Element in a Kenmore Elite Electric Dryer
If your Kenmore Elite Dryer is running but not heating, it may be time to change the heating element. Changing out the heating element is not a difficult task if you have a few basic tools and a little bit of expertise.
Instructions
1. Unplug the dryer. Locate and remove the front service panel on the bottom of the Kenmore dryer, located at the bottom of the dryer. The entire panel will pop off.
2. Remove 1 wire that runs from the heating element and test it by using a volt/ohm meter. You only need to remove 1 wire. This will provide enough ohms for a correct reading. If you are getting a zero reading, then the heating element is bad and should be replaced.
3. Take the heat shield off by pulling off the wires and removing the screws that secure the heating element in place. This will free the element. Remove the heating element.
4. Replace the heating element with a new element. Make sure it is securely in place and then screw the element back into the housing and reinstall the wires.
5. Reassemble the dryer by putting the front service panel back on. Plug the dryer back in, push it back into place and turn it on. Allow it to run for a few minutes to test the new element.
Related Posts:
Replace A Thermal Fuse In A Whirlpool Dryer
Replace a Thermal Fuse in a Whirlpool DryerThe motor of your Whirlpool dryer won't run even though the dryer has power. Rather than calling a repairman, you can test and repair the dryer yourself...
Replace An Electric Water Heater Element
If you don't seem to have the same amount of hot water available as you had before, you may have a bad heating element in the water heater. Over time, the heating element can become coated with ca...
Change The Oven Element In A Ge Spectra
Change the element to keep your GE Spectra oven running hot.A defective heating element can make your GE Spectra oven useless. If your oven will not heat up to the proper temperature or you see sp...
Disassemble A Ge Profile Dryer
Disassemble a GE Profile DryerTaking your GE dryer apart is necessary to make repairs. Familiarizing yourself with your dryer can save you hundreds in repair bills. Look at your dryer and recogniz...
Replace A Bulb In A Mitsubishi Dlp Tv Lamp
A million mirrors and one lamp give you the DLP experienceA Mitsubishi DLP TV delivers a picture known for its sharp and vivid color. If the lamp inside burns out, you can no longer watch TV in br...
